35
G. Select “OFF DAY” SETTING, and press the SET/
CANCEL button (5) once to apply the setting.
H. After the “OFF DAY” SETTING is completed, the
time indication on the schedule bar graph turns off.
The “OFF” mark lights at the specified day of the
week.
The set time indication changes from blinking to
constant On, and the display returns to screen B
(blinking Timer No. and “day of the week” indica-
tions) shown on page 34.
* Schedule setting cannot be made for the day for
“OFF DAY” SETTING is made, until the “OFF
DAY” SETTING is cancelled.
Refer to section C on page 34 for the method of
cancelling “OFF DAY” SETTING.
I. If no button is operated for 1 minute or the SCHED-
ULE button (1) is pressed once, the display returns
to the ALL screen when the setting was made in
the ALL screen, or to the INDIVIDUALLY screen
when the setting was made in the INDIVIDUALLY
screen.
[Screen Display: “OFF DAY” SETTING
Cancellation]
A. While the ALL or INDIVIDUALLY screen is dis-
played, press the SCHEDULE button (1) once.
B. The Schedule setting screen appears.
If no button is operated for 2 seconds while the dis-
play shows screen B to screen D on page 35, a
guidance message, “ BUTTONS: SELECT
TIMER No., BUTTONS: SELECT DAY OF
THE WEEK, SET/CANCEL BUTTON: SET,”
appears and scrolls in the operation mode display
section (dot matrix).
C. Press the ALL button (2) or one of the individual
group selection buttons (3) (1 - 16) to select the air
conditioner (group) for which the “OFF DAY” SET-
TING is to be cancelled.
D. Press the or button (4) to select the day of the
week for the cancellation of the “OFF DAY” SET-
TING.
G
H
I
A
B
C
D
01_EN_3P124623-10N.fm Page 35 Monday, January 28, 2008 4:58 PM
To Next Page
Loading...
