Danfoss AK2-SC 255 User Manual

180 AK2-SC 255 Reference Manual RS.8D.M1.22
IP Network
(Ethernet) Before theintroduction of the AK2-SC 255, theDanfoss AKC 55 systems used third
party Ethernet adapters. In the 255, Ethernet communications is supplied on board the
controller and no outboard equipment is required. The Ethernet configudration screen
is shown below.
The address required is an IP address, and is the address of the ethernet node to
which alarms are to be sent. The IP address is assigned by your network administra-
tor. The address is composed of four one-, two-, or three-digit numerals separated by
periods. None of the groups can be a number greater than 254 or less than 1.
The address required is an IP address, and is the address of the ethernet node to
which alarms are to be sent. The IP address is assigned by your network administra-
tor. The address is composed of four one-, two-, or three-digit numerals separated by

Danfoss AK2-SC 255 Specifications

General

Brand	Danfoss
Model	AK2-SC 255
Category	Controller
Language	English