Danfoss AK2-SC 255 - Page 54

RS.8D.M1.22 AK2-SC 255 Reference Manual 53
space. When the name appears as you want it, press
ENTER).
Bcast (List box:)
No: The value of the point will not be broadcast to be
used in logic on other controllers.
Send: The value of the point will be available on the
host network for use by other controllers. Be sure that
each sending Board-Point combination is unique
throughout the system. (If the controller at address #01
is sending from its Bd-Pt address 1-02, then no other
controller can have an output at its Bd-Pt address 1-02
sending.
Rec: The value of the point is being received from
another controller on the host network. You must enter,
in the Bd-Pt fields, the Bd-Pt address of the sending
point.
Bd-Pt Enter the Bd-Pt address to which the sensor is wired,
or, in the case of a received broadcast point, enter the
board and point address of the sending point.
Type (List box:)
AKS 32-100 Danfoss pressure sensor, 0 to 100 psig.
AKS 32-200 Danfoss pressure sensor, 0 to 200 psig.
AKS 32-500 Danfoss pressure sensor, 0 to 500 psig.
PHOTO-OD-1 Danfoss indoor-outdoor photocell
with type AKS 21 temperataure sensor.
PHOTO-ID Danfoss indoor photocell.
PT1000 Danfoss temperature sensor.
DPS100 Danfoss dew point sensor.
ECI TP-1 ECI temperature sensor type TP-1.
ECI TP-2 ECI temperature sensor type TP-2.
NOVAR Novar temperature sensor.
THERM3 Danfoss THERM3 low and medium range
temperature sensor.
THERM3-HT Danfoss high range THERM3
temperature sensor.
EMHS3 Danfoss humidity sensor, indoor, with
temperature sensor.
EMHS4 Danfoss humidity sensor, outdoor.
1-6 Volts A user-supplied linear-response sensor with
1 to 6 Volt output.
0-5 Volts A user-supplied linear-response sensor with
0 to 5 Volt output.
1-2 Volts A user-supplied linear-response sensor with
1 to 2 Volt output.
CTTS Com-Trol temperature sensor.