Danfoss vlt FC 102 - Page 175

18-38 Temp. Input X48/7
Range: Function:
0* [-500 - 500 ] View the actual temperature
measured at input X48/7. The
temperature unit is based on the
selection in parameter 35-02 Term.
X48/7 Temperature Unit.
18-39 Temp. Input X48/10
Range: Function:
0* [-500 - 500 ] View the actual temperature
measured at input X48/10. The
temperature unit is based on the
selection in parameter 35-04 Term.
X48/10 Temperature Unit.
3.17.4 18-4* PGIO Data Readouts
Parameters for conguring the readout of VLT
®
Programmable I/O .
18-43 Analog Out X49/7
Range: Function:
0* [0 - 30 ] Shows the actual value at output of
terminal X49/7 in V or mA. The
value reects the selection in
parameter 36-40 Terminal X49/7
Analogue Output.
18-44 Analog Out X49/9
Range: Function:
0* [0 - 30 ] Shows the actual value at output of
terminal X49/9 in V or mA. The
value reects the selection in
parameter 36-50 Terminal X49/9
Analogue Output.
18-45 Analog Out X49/11
Range: Function:
0* [0 - 30 ] Shows the actual value at output of
terminal X49/11 in V or mA. The
value reects the selection in
parameter 36-60 Terminal X49/11
Analogue Output.
3.17.5 18-5* Ref. & Feedb.
NOTICE
Sensorless readout requires set-up by MCT 10 Set-up
Software with sensorless specic plug-in.
18-50 Sensorless Readout [unit]
Range: Function:
0 Sensor-
lessUnit*
[-999999.999
- 999999.999
Sensor-
lessUnit]
18-57 Air Pressure to Flow Air Flow
Shows the air ow calculated using the measured pressure
dierence.
Range: Function:
0 AirPres-
ToFlowUnit
*
[0 - 999999
AirPresTo-
FlowUnit]
Readout value for air pressure to air
ow calculation.
18-60 Digital Input 2
Range: Function:
0* [0 - 65535 ] Shows the signal states from the
active digital inputs.
•
0 = No signal
•
1 = Connected signal.
Parameter Descriptions Programming Guide
M0010001 Danfoss A/S © 10/2019 All rights reserved. 173
3 3