Danfoss VLT Micro Drive FC 51 Design Guide

4
VLT
®
Micro Drive Selection
4.1 Options and Accessories
4.1.1 Local Control Panel (LCP)
For detailed information on programming, see
Programming Guide MG02C
.
NOTE
The frequency converter can also be programmed from a
PC
via
RS-485
com-port
by installing the MCT 10 Set-up
Software.
This
software can either be ordered using code number
130B1000 or downloaded from the DanfossWeb site: /
BusinessAreas/DrivesSolutions/software-download
Illustration 4.1 Description of LCP Buttons and Display
Use the [Menu] key to select one of the following menus:
Status:
For readouts only.
Quick
Menu:
For access to Quick Menus 1 and 2, respectively.
Main Menu:
For access to all parameters.
Navigation Keys:
[Back]: For moving to the previous step or layer in the
navigation structure.
Arrows [
▲
] [
▼
]: For maneuvering between parameter
groups, parameters and within parameters.
[Ok]: For selecting a parameter and for accepting changes
to parameter settings.
Operation Keys:
A
yellow light above the operation keys indicates the
active key.
[Hand on]: Starts the motor and enables control of the
frequency converter via the LCP.
[Off/Reset]: Stops the motor (off). If in alarm mode the
alarm will be reset.
[Auto on]: The frequency converter is controlled either via
control terminals or serial communication.
[Potentiometer] (LCP 12): The potentiometer works in two
ways depending on the mode in which the frequency
converter is running.
In Auto Mode the potentiometer acts as an extra
programmable analog input.
In Hand on Mode the potentiometer controls local
reference.
The LCP can be moved to the front of a cabinet by using
the remote build-in kit. The enclosure is the IP55.
Enclosure IP55 front
Max. cable length between and unit: 3 m
Communication std: RS-485
Ordering no. 132B0102
Table 4.1 Technical Data
VLT
®
Micro Drive Selection VLT
®
Micro Drive FC 51 Design Guide
26 MG02K202 - VLT
®
is a registered Danfoss trademark
44
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com

Danfoss VLT Micro Drive FC 51 Specifications

General

Enclosure	IP20
Output Voltage	0-100% of supply voltage
Altitude	Up to 1000 m without derating
Power Range	0.18-22 kW
Control Method	V/f
Communication	Modbus RTU
Protection Features	Over-voltage, under-voltage, over-current, over-temperature
Ambient Temperature	-10°C to 50°C
Storage Temperature	-25°C to 65°C
Relative Humidity	5-95% (non-condensing)
Input Voltage	200-240 V, 380-480 V
Braking Function	Integrated braking chopper (optional)