Datacolor AutoLab TF Series User Manual

AutoLab TF Dispenser Technical Manual – Revision 5
AutoLab TF dispensers Technical Manual TFTMTF / Rev 5.0 / 24
th
May 2006 Page 117 of 150
The procedures of changing Q type amplifier parameters
z By pressing MODE key, display system parameter editing mode “PA”.
z Switch as follows. (Page selection screen)
z Display the target page for editing by pressing UP/DOWN key. The value is increased by UP key
and decrease by DOWN key.
z Press WR key for 1 second. The setting data is indicated.
By press MODE key, return to procedure 3 (page selection screen).
z By pressing cursor key within 1 second, the highest figure flickers. The value which is flickering
can be edited. By pressing cursor key within 1 second, the next figure flickers. By pressing
UP/DOWN key, set the value which is to be edited.
z By pressing WR key for 1 second or more, the display flickers 3 times and the flicker stops. This
means that the data can be set.
* When save data out of setting range, display the data before editing without flickering 3
times. Reset in procedure 5.
z By press MODE key again, return to procedure 3. By pressing MODE key once again, the mode
shifts.

Datacolor AutoLab TF Series Specifications

General

Brand	Datacolor
Model	AutoLab TF Series
Category	Dispenser
Language	English