Datacolor AutoLab TF Series User Manual

AutoLab TF Dispenser Technical Manual – Revision 5
AutoLab TF dispensers Technical Manual TFTMTF / Rev 5.0 / 24
th
May 2006 Page 89 of 150
Precisa XT6200C
The detailed description of the menu options is given as below:
- To entry the configuration menu, hold down the “MENU” key about 10 seconds
when the power is on.
- To entry the application menu, after the start up process finished, hold down
the the “MENU” key about 5 seconds
- “
←” and “→” change from main menu path into sub-path and back.
- “
↑” and “↓” Up/down movement within the main and sub-paths.
Change selected parameter.
- “ ” Select parameters and store changed parameters.
- “Esc” Interrupt an input and leave the menu.
The settings of scale should be same as below:
Configuration Menu
NO. Main Menu Setting Sub-Menu Setting
1 Configuration
Factory Configuration
2 Unit 1
g
Auto-Start
On
Mode
Continuous
3 Set Data Print
Set Pringformat
All off
5 Set Calibration Mode
Internal
Floating Display
0.16
Stability
Low
Auto Standby
Off
Auto Zero
On
6 Set Weighing Mode
Quick Tare
Off
Baudrate
9600
Parity
8-NO-1Stop
7 Set interface
Handshake
No
8 Set Date and Time
As request
9 Set Password Data Protection
Off
10 THEFTCODE THEFT-protection
Off
11 Language Language
English
12 Contrast
6
Application Menu
NO. Main Menu Setting Sub-Menu Setting
1 Set App.
Off
2 Set Statistic Mode
Off
3 Set Check +/-
Off
4 Auto Start
Off
*It has to change the tare command in AutoLabTFCtrl－Parameter Setup－Engineer Setup－
Define tare command as “T”.

Datacolor AutoLab TF Series Specifications

General

Brand	Datacolor
Model	AutoLab TF Series
Category	Dispenser
Language	English