Datakom D-100 MK2 - Page 100

D-100 MK2 User Manual Firmware V-6.3
K96D01-EN - 100 -
The electronic engine fault codes are displayed in text within the alarm list table, together with their
SPN-FMI codes. The complete list of fault codes is given in the engine manufacturer’s user manual.
Below is a basic list of fault conditions (x denotes any FMI)
SPN
FMI
DESCRIPTION
56
x
Overspeed shutdown
57
x
Low oil pressure shutdown
58
x
High engine temp. shutdown
71
x
Gain adjust potentiometer fault
75
x
Generator speed circuit fault
79
x
Frequency adjust potentiometer fault
80
x
Droop adjust potentiometer fault
81
x
Low oil pressure warning
82
x
High engine temp. warning
91
x
Accelerator pedal circuit fault
94
x
Fuel filter restriction
Fuel pressure sensor fail
97
x
Water in Fuel
99
x
Oil filter differential pressure fault
98
x
Low oil level, High oil level, Oil level sensor fail
100
x
Low oil pressure, Oil pressure sensor fail
101
x
Crankcase pressure fault
102
x
Intake manifold 1 pressure fault
103
x
Turbocharger 1 speed fault
105
x
Intake manifold temp high, Intake manifold temp
sensor fail
106
x
High boost pressure, Turbo outlet pressure sensor
fail
107
x
Air filter restriction, Air filter sensor fail
108
x
Atmospheric pressure sensor fail
109
x
Coolant pressure fault
110
x
High coolant temperature, Coolant temperature
sensor fail
111
x
Low coolant level, Coolant level sensor fail
153
x
Crankcase ventilation fault
158
x
Battery voltage failure
164
x
High injector activation pressure, Injector activation
pressure sensor fail
168
x
Battery 1 voltage fault
172
x
High inlet air temperature, High inlet manifold air
temperature, Inlet manifold air temperature sensor
fail
173
x
Exhaust gas temp. fault
174
x
High fuel temperature, Fuel temperature sensor fail
175
x
High oil temperature, Oil temperature sensor fail
190
x
Overspeed, Speed sensor loss of signal, Speed
sensor mechanical failure