D-100 MK2 User Manual Firmware V-6.3
K96D01-EN - 88 -
The site identity string is designed to identify the current controller.
This is the site Id string sent at the beginning of SMS messages and web page headers for the
identification of the genset sending the message. Any 20 character long string may be entered.
The engine serial number string is designed to identify the current controller.
Th s string is added to GSM-SMS messages, web page headers etc.
These telephone number buffers accept up to 16 digits, including the wait character (“,”) in order to
enable dialing through a pabx.
If Modem Selection= External PSTN Modem: First 2 numbers are used for modem calls.
Other selections: all numbers are used for SMS sending.
Enter numbers starting from first character. Do not
leave blank characters at the beginning.
16.12. MODEM1-2/SMS1-2-3-4 TELEPHONE NUMBERS
16.11. ENGINE SERIAL NUMBER
To Next Page
Loading...
Need help?
General
