To Next Page

To Previous Page

Enter/Exit Programming Mode

Product Reference Guide

179

Code 93 Set Length 1

Specifies one of the bar code lengths for Code 93 Length Control. Length 1

is the minimum label length if in Variable Length Mode, or the first fixed

length if in Fixed Length Mode. Length includes the bar code’s data charac-

ters only. The length can be set from 01 to 50 characters.

Table 20 provides some examples for setting Length 1. See page 297 for

detailed instructions on setting this feature.

Table 20. Code 93 Length 1 Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

01 Characters 07 Characters 15 Characters 50 Characters

2 Scan ENTER/EXIT PROGRAMMING MODE

3 Scan SELECT CODE 93 LENGTH 1 SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘1’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’

5 Scan ENTER/EXIT PROGRAMMING MODE

Select Code 93 Length 1 Setting

To configure this feature, scan the ENTER/

EXIT bar code above, then the bar code at

left followed by digits from the Alphanu-

meric characters in Appendix D, Keypad

representing your desired c

haracter(s). End

by scanning the ENTER/EXIT bar code

again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

01 = Length 1 is 1 Character

Datalogic PowerScan 9100 Series User Manual

Questions and Answers: