To Next Page

To Previous Page

Enter/Exit Programming Mode

Product Reference Guide

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK char-

acter from the host following label transmission. The selectable timeout

nge is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments.

A selection of 0 disables the timeout.

See page 290 for more information on setting this feature.

Select ACK NAK Timeout Value Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the ENTER

/EXIT bar code twice.

Make a mistake? Scan the CANCEL bar code to abort

and not

save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

01 ACK NAK Timeout value is 200ms

ACK NAK Retry Count

This feature specifies the number of times the reader retries a label trans-

mission due to a retry condition. The selectabl

e range is from 1 to 254

retries. A selection of 0 disables the count, and a selection of 255 specifies

unlimited retries. See page 291 for more information.

Select ACK NAK Retry Count Setting