To Next Page

To Previous Page

Enter/Exit Programming Mode

Product Reference Guide

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.

ASCII characters or any hex value fr

om 0 to 0xFF can be selected.

See page 292 for more information on setting this feature.

Select Disable Character Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in

Appendix D, Keypad

repre-

senting your desired character(s). End by scanning

the ENTER

/EXIT bar code twice.

Make a mistake? Scan the CANCEL bar code to abort

and not

save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

0x44 = Disable Character is ‘D’

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.

ASCII characters or any hex value fr

om 0 to 0xFF can be selected.

See page 293 in “References” for more information on setting this feature.

Select Enable Character Setting