Datalogic PowerScan 9100 Series User Manual

Enter/Exit Programming Mode
250 PowerScan™ PD9130/PBT9100/PM9100
Changing System Speed
1. Link the PM9100 with a BC9xxx Base.
2. With the PM9100, read a New System Speed programming label.
3. Place the PM9100 into the BC9xxx.
Normal Mode: Low Speed (1)
Normal Mode: High Speed (3)
DEFAULT
The Reader and Base will now be linked at the new programmed speed.
This feature can also be programmed using Datalogic Aladdin.
1. On the BC9xxx Base, change the System Speed.
2. Place an unlinked PM9100 onto the BC9xxx base.
The Reader and base will link at
the new programmed speed.
CAUTION
Restore Default command does not modify this parameter.

Datalogic PowerScan 9100 Series Specifications

General

Brand	Datalogic
Model	PowerScan 9100 Series
Category	Barcode Reader
Language	English