To Next Page

To Previous Page

Enter/Exit Programming Mode

180

PowerScan™ PD9130/PBT9100/PM9100

Code 93 Set Length 2

This feature specifies one of the bar code lengths for Code 93 Length Con-

trol. Length 2 is the maximum label length if in Variable Length Mode, or the

second fixed length if in Fixed Length Mode. Length includes the bar code’s

check, data, and full-ASCII shift characte

rs. The length does not include

start/stop characters. The length can be set from 1 to 50 characters. A set-

ting of 0 specifies to ignore this length (only one fixed length).

Table 21 provides examples for setting Length 2. See page 298 for detailed

instructions on setting this feature.

Table 21. CODE 93 Length 2 Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

00 (Ignore This

Length)

07 Characters 15 Characters 50 Characters

2 Scan ENTER/EXIT PROGRAMMING MODE

3 Scan SELECT CODE 93 LENGTH 2 SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’

5 Scan ENTER/EXIT PROGRAMMING MODE

Select Code 93 Length 2 Setting

To configure this feature, scan the ENTER/

EXIT bar code above, then the bar code at

left followed by digits from the Alphanu-

meric characters in Appendix D, Keypad

representing your desire

d character(s). End

by scanning the ENTER/EXIT bar code

again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

50 = Length 2 is 50 Characters

Datalogic PowerScan 9100 Series User Manual

Questions and Answers: