Enter/Exit Programming Mode
Product Reference Guide
255
Display Contrast
Adjust the contrast of the display.
Set Display Contrast
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits (00-32 by 01) from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT
bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
Font Size
Select the font size
1
.
Font Size = Small
Font Size = Medium
Font Size = Large
1. 4-keys models only.
To Next Page
Loading...
