Enter/Exit Programming Mode
64
PowerScan™ PD9130/PBT9100/PM9100
Double Read Timeout
Double Read Timeout prevents a double read of the same label by setting
the minimum time allowed between reads of labels of the same symbology
and data. If the unit reads a label and sees the same label again within the
specified timeout, the second read is ignored. Double Read Timeout does
not apply to scan modes that require a trigger pull for each label read.
Double Read Timeout = 0.1 Second
Double Read Timeout = 0.2 Second
Double Read Timeout = 0.3 Second
Double Read Timeout = 0.4 Second
Double Read Timeout = 0.5 Second
Double Read Timeout = 0.6 Second
DEFAULT
Double Read Timeout = 0.7 Second
To Next Page
Loading...
