Datalogic PowerScan 9100 Series User Manual

Data Editing
Product Reference Guide 305
Table 42
STEP ACTION EXAMPLES
1.
Scan the ENTER/EXIT bar
co
de
(Scanner enters Programming Mode)
2.
Determine placement of
th
e Label ID characters
BEFORE or AFTER with
regard to scanned data
using
Label ID
Control, starting on
page 55
Enable as Pre-
fix
Enable as Suffix
Enable as Pre-
fix
Enable as Suffix
3.
Scan the bar code
selecting the symbology
type you wish to
desig
nate label ID
characters for using
Label
ID Symbology
Selection, starting on
page 56
.
DataBar
Omnidirectional
Code 39
Interleaved 2 of
5
Code 32
4.
Custom Label ID example
(desired characters):
D B * = C 3 + P H
5.
Find hex equivalents from
th
e
ASCII Chart(inside
back cover), then scan in
these digits/characters
using the bar codes in the
section:
Keypad, starting
on page 341
. If you make
a mistake before the last
character, scan the
CANCEL bar code to abort
and not save the entry
string. You can then start
again at the beginning.
44 42 2A 3D 43 33 2B 50 48
6.
Scan the ENTER/EXIT bar
co
de
(Scanner exits Label ID entry)
7.
Scan the ENTER/EXIT bar
code once again
(Scanner exits Programming Mode)
Result:
DB*[bar code
data]
[bar code
data]=C3
+[bar code data] [bar code data]PH
. Label ID Examples

Datalogic PowerScan 9100 Series Specifications

General

Brand	Datalogic
Model	PowerScan 9100 Series
Category	Barcode Reader
Language	English