Standard Defaults
340
PowerScan™ PD9130/PBT9100/PM9100
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan
either the Restore USA Factory Configuration bar code or the Restore EU
Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings, including the interface type.
CAUTION
Scanning either of the “Restore Factory Configuration” commands
below will result in the loss of any custom configuration settings
for your device. Go to
Restore Custom Defaults on page 17
if
you want to restore your custom configu
ration settings.
The USA label restores Label IDs to those historically used in the USA.
The EU label restores Label IDs to those historically used in Europe. The
Label ID sets for USA and EU are shown in Label ID: Pre-loaded Sets, starting
on page 302 of this manual.
Restore USA Factory Configuration
Restore EU Factory Configuration
To Next Page
Loading...
Need help?
General
