Deif PPU 300 - 2 Preparation for Commissioning; Tools; Tools Required

2. Preparation for commissioning
2.1 Tools
2.1.1 Tools required
The following tools are required for commissioning:
Tool Used to
Safety equipment Personal protection, according to local standards and requirements
Computer Run PICUS
Ethernet cable Connect the computer to the controller
PICUS
(The DEIF utility software)
• Draw the single-line drawing
• Configure the I/Os
• Configure the parameters
• Create CustomLogic
• Monitor operation (Live data and Supervision)
Bonjour
Network discovery of controllers on the DEIF network
INFO
Please refer to Apple's support page for Bonjour, regarding information and
downloading.
http://www.apple.com/support/bonjour/
See the PICUS manual for the system requirements to run PICUS.
DEIF supporters and other commissioning technicians have found these tools useful during controller commissioning:
Tool Used to
Multimeter, with accessories and
spare batteries
Check wiring
Measure the duty cycle for MPU and PWM terminals
Phase sequence meter Check the phase sequence
Synchroscope Check the synchronisation
Process meter Provide a 25 mA current signal for testing analogue-controlled regulators and wiring
Mirror or camera Look into the areas above and below the rack
Torch (US: Flashlight) Look at Ethernet cable wiring
Wire stripper, pliers and cutters
Change wiring
Trim cable ties
Screwdrivers
Change wiring
Swap hardware modules
See Preparing for the installation, Tools in the Installation instructions for more
information.
PPU 300 Commissioning guidelines 4189341106 UK
www.deif.com
Page 14 of 75