Deif PPU 300 - BUS TIE Breaker Controller Functions; Customised Functions and Sequences; Testing Customlogic

3. When the breaker closes, press Open breaker . Do the GENSET controllers with external set point (network)
activated de-load the breaker? Does the breaker open?
7.4.2 BUS TIE breaker controller functions
Functions
Synchronisation and de-
loading
• Broadcast the set point for GENSET controllers
◦ In the busbar A section, and in the busbar B section
Counters
• Display unit counters, to edit or reset
◦ Breaker operations and trips
◦ External breaker operations
◦ Power export (active, and reactive)
◦ Power import (active, and reactive)
◦ Power differential (active, and reactive)
• Energy counters with configurable digital outputs (for external counters)
◦ Power export (active, and reactive)
◦ Power import (active, and reactive)
◦ Power differential (active, and reactive)
7.5 Customised functions and sequences
7.5.1 Testing CustomLogic
CustomLogic performs PLC-type operations, to supplement the pre-programmed controller functions and sequences.
CustomLogic is optional.
Customised functions and sequences might have been created using CustomLogic during the design phase.
You can also create CustomLogic functions and sequences during commissioning. For example, you can use CustomLogic
to activate one of the controller's relay outputs when certain conditions are met.
The testing of CustomLogic depends on the specific functions and/or sequences created by the customer. DEIF cannot
therefore give any specific guidelines on testing the controller's CustomLogic.
See
CustomLogic in the Designer's handbook and in the PICUS manual for more information.
CAUTION
DEIF cannot take responsibility for functions or sequences that customers create in CustomLogic.
PPU 300 Commissioning guidelines 4189341106 UK
www.deif.com
Page 62 of 75