Document Contents
Designer's handbook
• Principles
• General controller sequences, functions and protections
• GENSET controller
• Protections and alarms
• AC configuration and nominal settings
• Breaker and synchronisation
• Regulation
• Load sharing
• Hardware characteristics
• PICUS (including permissions)
• CustomLogic
• Modbus
Installation instructions
• Tools and materials
• Mounting
• Minimum wiring for the controller
• Wiring for hardware module terminals
• Wiring for controller functions
• Wiring communication
• Wiring the display unit
Commissioning guidelines
• Tools, software and information required
• Controller, system and equipment checks
• Regulator tuning
• System testing
• Troubleshooting
Operator's manual
• Controller equipment (push-buttons and LEDs)
• Operating the system
• Alarms and log
• Using the display unit
• Troubleshooting and maintenance
PICUS manual Using PICUS and CustomLogic
Modbus tables
• Modbus address list
◦ PLC addresses
◦ Corresponding controller functions
• Descriptions for function codes, function groups
1.2 Warnings and safety
1.2.1 Safety during installation and operation
Installing and operating the equipment may require work with dangerous currents and voltages. The installation must only be
carried out by authorised personnel who understand the risks involved in working with electrical equipment.
PPU 300 Commissioning guidelines 4189341106 UK
www.deif.com Page 9 of 75
To Next Page
Loading...
