Tool Used to
Active load bank(s)*
Measure speed droop
Tune governors
Fully test generation capacity
Reactive load bank(s)*
Measure voltage droop
Tune AVRs
Fully test generation capacity
*Note: Load banks are optional. They are only required if the loads available during commissioning are small compared to the
generation capacity.
INFO
The controller's analogue output, to control the governor or AVR, can be selected to be either voltage or current.
You therefore do not need a set of resistors to convert a current output to a voltage output.
2.2 Software
2.2.1 Downloading and installing PICUS
Downloading PICUS
1. Visit:
http://www.deif.com/software.
2. Scroll to Software download and choose Multi-line 300, PICUS ver. 1.x.x software.
3. Submit your email address to receive a download link.
4. Follow the link to download PICUS.
Installing PICUS
1. Launch the PICUS installer from your computer.
2. Follow the instructions in the installer program.
See the
PICUS manual for further information on how to download and install PICUS.
CAUTION
You must install Bonjour, if you do not already have this installed on your computer. This service is used for the
network detection on the DEIF network. PICUS uses Bonjour to detect all controllers that are connected to the same
network. No additional configuration is required.
2.3 Information
2.3.1
System drawings
The following drawings must be available:
PPU 300 Commissioning guidelines 4189341106 UK
www.deif.com Page 15 of 75
To Next Page
Loading...
