Deif PPU 300 - 5. Using the Display Unit; Display Unit Introduction; About the Display Unit; Status Bar Information

Pair the display unit to the controller
Figure 3.3 Example initial Pair screen
• ID: The controller ID.
• Label: The controller label.
• Host name: The host name from the controller.
• Hops: The number of hops used to reach the controller.
INFO
The number of hops shown indicate how close the controller may be to the display unit. 1 hop typically indicates the
controller that the display unit is actually plugged in to.
1. Highlight the required controller.
2. Press OK to select the controller for pairing.
• A confirmation is shown on the display:
•
• Press OK to confirm the pairing.
INFO
The display unit now restarts and connects to the controller.
PPU 300 Commissioning guidelines 4189341106 UK
www.deif.com
Page 24 of 75