g. OCP card (if installed).
h. Versabay assembly (Power Interposer Board).
i. Side wall brackets.
j. Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board
from the system.
Steps
1. Using the Phillips #2 screwdriver, remove the screws that secure the system board to the chassis.
2. Using the system board holder and plunger, slide the system board towards the front of the system.
3. Lift the system board out of the chassis.
Figure 106. Removing the system board
Next steps
Install the system board.
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC
MAC address label of the replacement system board.
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in Before working inside your system on page 24.
3. If you are replacing the system board, remove all the components that are listed in the removing the system board section.
Steps
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board holder and plunger, lower the system board into the system.
100
Installing and removing system components
To Next Page
Loading...
