Figure 108. Removing the Rear IO card and LOM card
Next steps
Replace the Rear IO card and LOM card.
Installing the Rear IO card and LOM card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. Remove the system board.
Steps
1. Align the connectors and slots on Rear IO card and LOM card with the connector and standoffs on the system board.
2. Press the Rear IO card and LOM card until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the Rear IO card and LOM card to the system board with the two screws.
Installing and removing system components
103
To Next Page
Loading...
