Next steps
1. Install the side wall bracket.
2. Install the cooling fan assembly.
3. Install the middle top cover.
4. Install the air shroud.
5. Follow the procedure listed in After working inside your system on page 24.
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. Remove the middle top cover.
4. Remove the air shroud.
5. Remove the cooling fan assembly.
6. Remove the side wall bracket.
Steps
1. Disconnect the control panel cable from the connector on the system board.
2. Using the Phillips #1 screwdriver, remove the 16 screws that secure the front top cover to the system.
Figure 125. Removing the front top cover
3. Using the Phillips #1 screwdriver, remove the four screws that secure the left control panel to the system.
4. Hold the left control panel cable, and slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
118 Installing and removing system components
To Next Page
Loading...
