3. Press the release levers to lock the cooling fan cage assembly into the system.
Figure 30. Installing the cooling fan cage assembly
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system on page 24.
Side wall brackets
Removing the side wall bracket
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. Remove the middle top cover.
4. Remove the GPU air shroud.
5. Remove the air shroud.
6. Remove the cooling fan assembly.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the tab to open the side wall bracket cover.
NOTE: Unroute the cables to release them from the side wall bracket.
2. Lift the bracket to release it from the chassis.
NOTE: The procedure is same for both the side wall brackets.
Installing and removing system components 39
To Next Page
Loading...
