Next steps
1. Install the following components:
a. System board.
b. Power supply units (PSU).
c. OCP card (if installed).
d. Processor.
e. Heat sink.
f. Memory modules.
g. Cooling fan cage assembly.
h. Air shroud.
i. Nvidia A100 GPU assembly.
j. GPU air shroud.
k. Middle top cover.
2. Connect any cables which were previously disconnected from the components.
3. Follow the procedure listed in After working inside your system on page 24.
Control panel
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. Remove the middle top cover.
4. Remove the air shroud.
5. Remove the cooling fan assembly.
6. Remove the side wall bracket.
Steps
1. Using the Phillips #1 screwdriver, remove the 16 screws that secure the front top cover and the four screws securing the
right control panel.
114
Installing and removing system components
To Next Page
Loading...
