Figure 73. Installing the heat sink
Next steps
1. Install the air shroud.
2. Follow the procedure listed in the After working inside your system on page 24.
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported or
missing. It does not prevent your system from turning on. However, if a F1/F2 pause occurs with an error message,
see Troubleshooting expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/
poweredgemanuals.
Expansion card installation guidelines
The following table describes the supported expansion cards:
Table 16. Expansion card riser configuration 1
PCIe slots Width Length Height Processor 1 Processor 2 Processor 2 Processor 2
Riser 1A Riser 2C Riser 3D Riser 4B
Slot 2 DW HL FH x16 - - -
Slot 6 SW HL LP - x16 - -
Slot 7 SW HL FH - - - x8
Slot 8 SW HL FH - - - x8
Table 17. Expansion card riser configuration 2
PCIe slots Width Length Height Processor 1 Processor 2 Processor 2 Processor 2
Riser 1A Riser 2C Riser 3D Riser 4A
Slot 2 DW HL FH x16 - - -
Installing and removing system components 73
To Next Page
Loading...
