Next steps
Replace the power distribution board (PDB).
Installing the power distribution board (PDB)
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. Remove all the components that are listed in the removing the power distribution board (PDB) section.
Steps
1. Align the PDB to the PDB tray and secure it with the screws.
Figure 116. Installing the PDB
2. Align the PDB tray handle to the PDB tray and lock the plungers.
3. Align the PDB tray to the guiding pins in the chassis and lower it and slide to the front of the system.
4. Lock the plungers on the PDB tray to secure it to the chassis.
110
Installing and removing system components
To Next Page
Loading...
