Figure 55. Installing the thermal sponge bracket
Next steps
1. Install the cooling fan cage.
2. Install the GPU air shroud.
3. Connect the drive backplane cables to the connector on the backplane.
4. Install the middle top cover.
5. Follow the procedure listed in After working inside your system on page 24.
Hot-plug fan board
Hot-plug fan board view
Figure 56. Hot-plug fan board connectors
1. HPFB-FAN_PWR_T/B (power connector)
2. HPFB plunger
3. HPFB-SIG1_T/B (signal connector)
Removing the hot-plug fan board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 23.
2. Follow the procedure listed in the Before working inside your system on page 24.
3. If installed, remove the front bezel.
4. Remove the GPU fans.
58
Installing and removing system components
To Next Page
Loading...
