Figure 89. Installing expansion card in Riser 2
8. For Riser 3, align the cables to the connectors on Riser 3 and press until it is firmly connected.
Figure 90. Connecting cables for Riser 3
9. Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.
10. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
11. Close the expansion card retention latch.
12. Push the black card holder to hold the card in the riser.
NOTE: The procedure is similar for Riser 4.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 85
To Next Page
Loading...
