Dell PowerConnect 3524P - Page 125

Configuring System Information 125
• Severity to Include — The following are the available severity levels:
–
Emergency —The system is not functioning.
–
Alert — The system needs immediate attention.
–
Critical — The system is in a critical state.
–
Error — A system error has occurred.
–
Warning — A system warning has occurred.
–
Notice — The system is functioning properly, but system notice has occurred.
–
Informational — Provides device information.
–
Debug — Provides detailed information about the log. If a Debug error occurs, contact Customer
Tech Support.
•
Delete Server — Deletes the currently selected server from the Available Servers list, when selected.
When adding a Log Server, the following additional parameters are available:
• Supported IP Format — Specifies the IP format supported by the server. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.
•
IPv6 Address Type — When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local — A Link Local address that is non-routable and used for communication on the same
network only.
–
Global — A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface — When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1 — The IPv6 interface is configured on VLAN1.
•
ISATAP — The IPv6 interface is configured on ISATAP tunnel.
Sending Logs to a Server:
1 Open the Remote Log Server Settings page.
2 Select a server from the Available Servers drop-down list.
3 Define the fields.
4 Select the log severity in the Severity to Include check boxes.
5 Click Apply Changes .
The log settings are saved, and the device is updated.