Dell PowerConnect 3524P

228 Configuring System Information
• Security Level — The security level attached to the group. Security levels apply to SNMPv3 only.
The possible field values are:
–
No Authentication — Neither the Authentication nor the Privacy security levels are assigned to
the group.
–
Authentication — Authenticates SNMP messages, and ensures the SNMP messages origin is
authenticated.
–
Privacy — Encrypts SNMP message.
•
Operation — Defines the group access rights. The possible field values are:
–
Read — The management access is restricted to read-only, and changes cannot be made to the
assigned SNMP view.
–
Write — The management access is read-write and changes can be made to the assigned SNMP
view.
–
Notify — Sends traps for the assigned SNMP view.
Defining SNMP Groups
1 Open the Access Control Group page.
2 Click Add .
The
Add an Access Control Group page opens.
Figure 6-92. Add an Access Control Group
3 Define the fields in the Add an Access Control Group page.
4 Click Apply Changes .
The group is added, and the device is updated.