Dell PowerConnect 3524P - Page 229

Configuring System Information 229
Displaying the Access Table
1 Open the Access Control Group page.
2 Click Show All .
The
Access Table opens.
Figure 6-93. Access Table
Removing SNMP Groups
1 Open the Access Control Group page .
2 Click Show All .
The
Access Table opens.
3 Select a SNMP group.
4 Check the Remove checkbox.
5 Click Apply Changes .
The SNMP group is deleted, and the device is updated.
Defining SNMP Access Control Using CLI Commands
The following table summarizes the equivalent CLI commands for defining fields displayed in the
Access Control Group page.
The following is an example of the CLI commands:
Table 6-48. SNMP Access Control CLI Commands
CLI Command Description
snmp-server group groupname {v1 | v2 | v3
{noauth | auth | priv}} [read readview]
[write writeview] [notify notifyview ]
Configure a new Simple Network Management Protocol (SNMP)
group, or a table that maps SNMP users to SNMP views.
show snmp groups [groupname] Displays the configuration of groups
console (config)# snmp-server group user-group v3 priv read user-
view