Dell PowerConnect 3524P

Configuring Switch Information 305
• LAG Type — The port types that comprise the LAG.
•
Admin Status — Enables or disables the selected LAG.
–
Up — Traffic is enabled through the LAG.
–
Down — Traffic is disabled through the LAG.
•
Current Status — Indicates if the LAG is currently operating.
•
Admin Speed — The configured speed at which the LAG is operating. The possible field values are:
–
10M — Indicates the LAG is currently operating at 10 Mbps.
–
100M — Indicates the LAG is currently operating at 100 Mbps.
–
1000M — Indicates the LAG is currently operating at 1000 Mbps.
•
Current Speed — The speed at which the LAG is currently operating.
•
Admin Auto Negotiation — Auto Negotiation is a protocol between two link partners that enables a
LAG to advertise its transmission rate, duplex mode and flow control abilities to its partner.
–
Enable — Enables Auto Negotiation on the LAG.
–
Disable — Disables Auto Negotiation on the LAG.
•
Current Auto Negotiation — The current Auto Negotiation setting.
•
Admin Advertisement — Defines the auto-negotiation setting the LAG advertises. The possible field
values are:
–
Max Capability — Indicates that all LAG speeds and Duplex mode settings are accepted.
–
10 Full — Indicates that the LAG advertises for a 10 mbps speed LAG and full duplex mode
setting.
–
100 Full — Indicates that the LAG advertises for a 100 mbps speed LAG and full duplex mode
setting.
–
1000 Full — Indicates that the LAG advertises for a 1000 mbps speed LAG and full duplex mode
setting.
•
Current Advertisement — The LAG advertises its speed to its neighbor LAG to start the negotiation
process. The possible field values are those specified in the
Admin Advertisement field.
•
Neighbor Advertisement — Indicates the neighboring LAG advertisement settings. The field values
are identical to the
Admin Advertisement field values.
•
Admin Flow Control — Indicates the flow control status on the LAG. Flow Control mode is effective
on the ports operating in Full Duplex in the LAG.
–
Enable — Enables flow control on the LAG.
–
Disable — Disables flow control on the LAG.
–
Auto-negotiation — Enables the auto negotiation of flow control on the LAG.