Dell PowerConnect 3524P

Configuring Switch Information 307
3 Define the available fields for the relevant LAGs.
4 Click Apply Changes .
The LAG parameters are saved to the device.
Configuring LAGs with CLI Commands
The following table summarizes the equivalent CLI commands for configuring LAGs as displayed in the
Ports - LAG Configuration page.
Table 7-13. LAG Configuration CLI Commands
CLI Command Description
interface port-channel port-channel-
number
Enters the interface configuration mode of a specific
port-channel.
description string Adds a description to an interface configuration.
shutdown Disables interfaces that are part of the currently set
context.
speed bps Configures the speed of a given ethernet interface when
not using auto negotiation.
negotiation [capability1
[capability2…capability5]
Enables interface speed auto negotiation operation.
back-pressure Enables Back Pressure on a given interface.
flowcontrol {auto | on | off } Configures the Flow Control on a given interface.
show interfaces configuration
[
ethernet interface| port-channel
port-channel-number
]
Displays the configuration for all configured interfaces.
show interfaces status
[ethernet
interface
|port-channel port-channel-
number
]
Displays the status for all configured interfaces.
show interfaces description
[ethernet interface |port-channel
port-channel-number
]
Displays the description for all configured interfaces.
show interfaces port-channel
[port-
channel-number
]
Displays Port-channel information (which ports are
members of that port-channel, and whether they are
currently active or not).