Configuring Switch Information 391
The following table contains the IGMP port and LAG members management settings:
Adding Bridge Multicast Addresses
1
Open the
Bridge Multicast Group
page.
2
Click
Add
.
The
Add Bridge Multicast Group
page opens.
Figure 7-72. Add Bridge Multicast Group
3
Define the
VLAN ID
and
New Bridge Multicast Address
fields.
4
Toggle a port to
S
to join the port to the selected Multicast group.
5
Toggle a port to
F
to forbid adding specific Multicast addresses to a specific port.
6
Click
Apply Changes
.
The bridge Multicast address is assigned to the Multicast group, and the device is updated.
Table 7-39. IGMP Port/LAG Members Table Control Settings
Port Control Definition
D The port/LAG has joined the Multicast group dynamically in the Current Row.
S Attaches the port to the Multicast group as static member in the Static Row.
The port/LAG has joined the Multicast group statically in the Current Row.
F Forbidden.
Blank The port is not attached to a Multicast group.
To Next Page
Loading...
