Configuring Device Information 283
The following is an example of the CLI commands:
Console (config)# interface ethernet g5
Console (config-if)# description RD SW#3
Console (config-if)# shutdown
Console (config-if)# no shutdown
Console (config-if)# speed 100
Console (config-if)# duplex full
Console (config-if)# negotiation
Console (config-if)# back-pressure
Console (config-if)# flowcontrol on
Console (config-if)# mdix auto
Console (config-if)# exit
Console (config)# exit
Console# show interfaces configuration ethernet g5
Port Type Duplex Speed Neg Flow
Control
Admin
State
Back
Pressure
Mdix
Mode
---- ----- ------ ------ ---- ------ ----- ------ ----
g5 1G Full 100 Enabled On Up Enable Auto
console#
console# show interfaces status ethernet g5
Port Type Duplex Speed Neg Flow
Control
Link
State
Back
Pressure
Mdix
Mode
---- ----- ------ ------ ---- ------ ----- ------ ----
g5 1G Full 100 Enabled On Up Disabled on
console#
To Next Page
Loading...
