418 Configuring Quality of Service
Displaying the Bandwidth Settings Table:
1
Open the
Bandwidth Settings
page.
2
Click
Show All
.
The Bandwidth Settings Table opens.
Figure 9-5. Bandwidth Settings Table
Assigning Bandwidth Settings Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the Bandwidth
Settings page.
Table 9-5. Bandwidth Settings CLI Commands
CLI Command Description
traffic-shape committed-rate [committed-burst]
no traffic-shape
Sets shaper on egress port. Use no form in order
to disable the shaper.
rate-limit rate
no rate-limit
Limits the rate of incoming traffic. Use no form
in order to disable rate limit.
To Next Page
Loading...
