Dell PowerEdge R7625 - Page 126

Figure 93. C6-1: 16 x 2.5-inch SAS4/SATA RAID + 8 x U.2 G4 (w/ FPERC11)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 91. 16 x 2.5-inch SAS4/SATA RAID + 8 x U.2 G4 (w/ FPERC11)
Order From To
1 SL1_CPU2_PA4 (signal connector on system
board)
DST_PA1 (backplane signal connector)
2 SL2_CPU2_PB4 (signal connector on system
board)
DST_PB1 (backplane signal connector)
3 SL3_CPU1_PA1 (signal connector on system
board)
CTRL_DST_PA1 (fPERC input connector)
4 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
5 CTRL_SRC_SB1 (fPERC controller connector) BP_DST_SA1 (backplane expander signal
connector)
6 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
7 SL4_CPU1_PB1 (signal connector on system
board)
DST_PA2 (backplane signal connector)
8 SL5_CPU1_PB2 (signal connector on system
board)
DST_PB2 (backplane signal connector)
9 BP_PWR_0 (rear backplane power connector) BP_PWR_1 (backplane power connector)
126 Installing and removing system components