Installing input and output panel bracket
1. Insert the input and output(I/O) panel into the metal bracket.
2. Replace the screws to secure the I/O panel bracket to the I/O panel.
3. Install the:
a) front input and output panel
b) front input and output bezel
c) 5.25 inch ODD bracket
d) front bezel
e) side cover
4. Follow the procedure in After working inside your computer.
Intrusion switch
Removing the Intrusion switch
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) side cover
b) front bezel
c) 5.25 inch ODD bracket
3. To remove the intrusion switch:
a) Disconnect the intrusion cable [1] from the I/O module.
b) Remove the screw [2] that secures the intrusion switch to the chassis.
c) Lift the intrusion switch and remove it from the chassis.
NOTE: The system will not power on without the intrusion switch installed.
Removing and installing components 45
To Next Page
Loading...
