Installing the front system fan
1 Align the front system fan to its retention slot in the system chassis.
2 Replace the screw that secures the front system fan to the chassis.
3 Connect the fan cable to the system board.
4 Route the following cables through the cable holder and connect to the system board:
• SATA and ODD cables
• USB 3.1 cable
5 Install the:
a PCIe holder
b front bezel
c side cover
6 Follow the procedure in After working inside your computer.
System board
Removing system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a side cover
b air shroud
c expansion card
d memory module
e heat sink and CPU fan assembly
f front bezel
g ODD
h 5.25 ODD bracket
i system fan
j PCIe card holder
3 To remove the system board:
a To remove the system fan xed bracket, remove the screw [1] that secure the xed bracket to the system board.
b Lift the system fan xed bracket from the system board [2].
52
Removing and installing components
To Next Page
Loading...
Need help?
General