About this task
The figure indicates the location of the inner frame and provides a visual representation of the installation procedure.
Steps
1. Align and place the inner frame in the computer chassis.
2. Replace the five (M2x6) and the nine (M2x2) screws that secure the inner frame to the computer chassis.
3. Route the WLAN antennas and speaker cable using the routing guide on the inner frame.
Next steps
1. Install the long CAMM module.
NOTE: For models shipped with long CAMM module.
2. Install the battery.
3. Install the secondary solid-state drive.
4. Install the primary solid-state drive.
5. Install the base cover.
6. Follow the procedure in after working inside your computer.
Removing and installing components
61
To Next Page
Loading...
