Dell Precision 7680 - Removing SD card reader FPC

Steps
1.
NOTE:
Before installing the display assembly, ensure that the display hinges are opened to a 90-degree angle against
the display assembly, to fit the display assembly to the palm rest.
Align the screw holes on the hinges on the display assembly to the screw holes on the palm rest.
2. Replace the six (M2.5x3) screws to secure the hinges to the palm rest.
Next steps
1. Install the inner frame.
2. Install the heat-sink for integrated graphics or heat-sink for discrete graphics.
3. Install the secondary solid-state drive.
4. Install the primary solid-state drive.
5. Install the interposer board module.
6. Install the CAMM module or long CAMM module or memory module.
7. Install the battery.
8. Install the SIM card.
9. Install the base cover.
10. Follow the procedure in after working inside your computer.
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the SIM card.
4. Remove the battery.
Removing and installing components
77