Chapter 4 Parameters|VFD-VL
4-93
08-02
Rated Power of Motor
Control
mode
FOCPM
Factory setting: #.##
Settings 0.00 to 655.35 kW
It is used to set rated power of the motor. The factory setting is the power of the drive.
08-03
Rated Speed of Motor (rpm)
Control
mode
FOCPM
Factory setting: 1710
Settings 0 to 65535 rpm
It is used to set the rated speed of the motor and need to set according to the value indicated
on the motor nameplate.
08-04
Number of Motor Poles
Control
mode
FOCPM
Factory setting: 4
Settings 2 to 96
It is used to set the number of motor poles (must be an even number).
08-05
Rs of Motor
Control
mode
FOCPM
Factory setting: 0.000
Settings
0.000~65.535Ω
08-06
Ld of Motor
Control
mode
FOCPM
Factory setting: 0.0
08-07
Lq of Motor
Control
mode
FOCPM
Factory setting: 0.0
Settings 0.0~6553.5mH
08-08
Back Electromotive Force
Control
mode
FOCPM
Factory setting: 0.0
Settings 0.0~6553.5Vrms
This parameter is used to set back electromotive force (phase-phase RMS value) when the
motor is operated in the rated speed.
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
Need help?
General