ENGLISH FRANCAIS
o SAFETY PRECAUTIONS
SAFETY INSTRUCTIONS
13.
Power-Cord Protection - Power-supply cords should be routed so that they
are not likely
to
be walked on or pinched by items placed upon or against
them, paying particular atten ion to cords at plugs, convenience receptacles,
and the point where they exit from the product.
15.
Outdoor Antenna Grounding - If
an
outside antenna or cable system
is
connected to the product,
be
sure the antenna or cable system
is
grounded
so
as
to provide some protection against voltage surges and built-up static
charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides
information with regard
to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to
an
antenna discharge unit. size
of
grounding conductors, location
of
antenna-discharge unit. connection to
grounding electrodes, and requirements for the grounding electrode. See
Figure
A.
16.
Lightning -
For
added protection for this product during a lightning storm,
or
when
it
is
left unattended and unused for long periods
of
time, unplug it
from the wall outlet and disconnect the antenna or cable system. This will
prevent damage
to
the product due
to
lightning and power-line surges.
17.
Power Lines - An outside antenna system should not be located
in
the
vicinity of overhead power lines or other electric light or
power
circuits, or
where it
can
fall into such power lines or circuits. When installing an outside
antenna system, extreme care should be taken
to
keep from touching such
power lines or circuits
as
contact
with
them might
be
fatal.
18.
Overloading - Do not overload wall outlets, extension cords, or Integral
convenience receptacles
as
this
can
result
in
a risk of fire or electric shock.
19.
Object and Liquid Entry - Never push objects of any kind into this product
through openings
as
they may touch dangerous voltage points or short-out
parts that could result
in
a fire or electric shock. Never spill liquid of any kind
on the product.
20. Servicing - Do not attempt
to
service this product yourself
as
opening or
removing covers may expose you
to
dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
21.
Damage Requiring Service - Unplug this product from the wall outlet
and refer servicing to qualified service personnel under the following
conditions:
a)
When
the power-supply cord or plug is damaged,
b)
If liquid has been spilled, or objects have fallen into the product,
cl
If the product
has
been exposed to rain or water,
d)
If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
instructions
as
an
improper adjustment of other controls may result
in
damage and will often require extensive work by a qualified technician to
restore the product to its normal operation,
e)
If the product has been dropped
or
damaged
in
any way, and
f)
When
the product exhibits a distinct change
in
performance - this
indicates a need for service.
22. Replacement Parts - When replacement parts are required, be sure the
service technician has used replacement parts specified by the manufacturer
or have the same characteristics
as
the original part. Unauthorized
substitutions may result
in
fire, electric shock, or other hazards.
23. Safety Check - Upon completion
of
any service or repairs
to
this product,
ask the service technician to perform safety checks
to
determine that the
product is
in
proper operating condition.
24.
Wall or Ceiling Mounting - The product should be
mounted
to
a wall
or
ceiling only
as
recommended by the manufacturer.
25. Heat - The product should
be
situated away from heat sources such
as
radiators, heat registers, stoves, or other products (including amplifiers) that
produce heat.
ANTENNA
LEAD
IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEG SECTION 610·20}
elECTRIC
SERVICE
EQUIPMENT~---J
n-
I
FIGURE A
EXAMPLE
OF
ANTENNA GROUNDING
AS
PER
NATIONAL
elECTRICAL CODE
2.
1.
3
4.
5.
6
7.
__
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
NEe·
NATIONAL ELECTRICAL CODE INEG ART 250. PART H)
8
9
Read
Instructions - All the safety and operating instructions should be read
before the product
is
operated.
Retain Instructions - The safety and operating instructions should be
retained for future reference.
Heed Warnings - All warnings on the product and
in
the operating
instructions should
be
adhered to.
Follow Instructions - All operating and use instructions should
be
followed.
Cleaning - Unplug this product from the wall outlet before cleaning. Do not
use liquid cleaners or aerosol cleaners.
Attachments -
Do
not use attachments not recommended by the product
manufacturer
as
they may cause hazards.
Water and Moisture - Do not use this product near water - for example,
near a bath tub, wash bowl, kitchen sink.
or
laundry tub;
in
a
wet
basement;
or near a
swimming
pool; and the like.
Accessories - Do not place this product on
an
unstable cart, stand, tripod,
brac et. or table. The product may fall, causing serious injury to a child or
adult. and serious damage
to
the product. Use only With a cart, stand,
tripod, bracket, or table recommended by
he
manufacturer, or sold
with
the
product. Any mounting of the product should
follow the manufacturer's instructions, and should
use a mounting accessory recommended by the
manufacturer.
A product and cart combination should be moved
with
care. Quick stops, excessive force, and
uneven surfaces may cause the product and cart
combination to overturn.
10.
Ventilation - Slots and openings
in
the cabinet are provided for ventilation
and to ensure reliable operation
of
the product and to protect
it
from
overheating, and these openings
must
not be blocked or covered. The
openings should never be blocked by placing the product on a bed, sofa,
rug, or other similar surface. This product should not
be
placed
in
a built-in
Installation such
as
a bookcase or rack unless proper ventilation
is
provided
or
the manufacturer's instructions have been adhered to.
11.
Power Sources - This product should be operated only from the type of
power source indicated on the marking label. If you are not sure of the ype
of power supply to your home, consult your product dealer or local power
company.
For
products intended to operate from battery power, or other
sources, refer to the operating instructions.
12.
Grounding or Polarization - This product may be equipped With a polarized
alternating-current line plug
(a
plug having one blade wider than the other).
This plug will fit Into the power outlet only one way. This
is
a safety feature.
If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit. contact your electrician
to
replace your
obsolete outlet. Do not defeat the safety purpose
of
the polarized plug.
CAUTION
RISK
OF
ELECTRIC
SHOCK
A.
DO NOTOPEN
~
The lightning flash
with
arrowhead symbol, within
an
equilateral
triangle,
IS
intended
to
alert the user
10
the presence
of
uninsulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point Within
an
equilateral triangle is intended
to alert the user to the presence of important operating
and maintenance (servicing) instructions
in
the literature
accompanying the appliance.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT
REMOVE
COVER (OR BACK).
NO
USER-SERVICEABLE PARTS INSIDE.
REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING:
TO REDUCE THE RISK OF FIRE
OR
ELECTRIC SHOCK, DO
NOT
EXPOSE THIS APPLIANCE TO RAIN
OR
MOISTURE.
To Next Page
Loading...
Need help?
General
