ENGLISH
Remote
Control
Unit
Operations
I
Main Remote Control Unit
(RC-1099)
[Front]
[SOURCE
_--"'---"":-lr'~'
[SOURCE
CONTROL
1]
~~
CONTROL
2]
[Rear]
[ZONE2
OFF]
II
9mn_n~1
[MAIN
ONI
:GJGJGJ:
[NUMBER]
~GJ
GJ
0!
i,Q.0_8.i
i,G),:
Depending
on
the model
and
year of manufacture of your equipment.
some buttons may not operate.
65
o erating DENON Audio Com onents
1Set
[SOURCE
CONTROL
1]
to "AUDIO".
--------_._------------
•.
_-_.
-
2
Set
[SOURCE
CONTROL
2]
to the position for the
component to be operated (CD, iPodlNETWORK or
TUNER).
3Operate the audio component.
'*
For
details, refer to the component's operating instructions.
'*
While this remote control
is
compatible with a wide
range
of
infrared controlled components, it may
be
the case that some
component models cannot
be
operated with this remote control.
Presetting
• DENON and other makes of components
can
be
operated by
setting the preset memory.
• Operation
is
not possible for some models.
1Set
[SOURCE
CONTROL
1]
to
"AUDIO" or ''VIDEO''.
'*
Set to the AUDIO side for the
CD
position, and to the
VIDEO
side
for the DVDNDP,
VCR,
SAT/CABLE or
TV
position.
2
Set
[SOURCE
CONTROL
2]
to the component to be
registered.
3
Press
[ZONE2
OFF]
and
[MAIN
ON]
at the same time.
The indicator starts flashing.
4
Press
[NUMBER]
and input the 3·digit number
of
the
brand
of
the component to be preset. The numbers
are shown in the Preset Code Table (iGT'End
of
this
manual).
5
To store the codes
of
another component in the
memory, repeat steps 1 to 4.
•
The
signals for the pressed buttons
are
emitted while setting the
preset memory.
To
avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset
memory.
• Depending
on
the model
and
year of manufacture, this function
cannot
be
used for some models, even if they are of makes listed
in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number
and
verify correct operation.
•
The
preset memory
can
be
set for one component only among the
following: DVDNDP
and
SAT/CABLE.
II
Operating Preset Components
II
1Set
[SOURCE
CONTROL
1]
to
"AUDIO" or "VIDEO".
'*
Set to the AUDIO side for the
CD
position, and to the VIDEO side
for the DVDNDP,
VCR,
SAT/CABLE or
TV
position.
2
Set
[SOURCE
CONTROl2]
to the component you want
to operate.
3Operate the component.
'*
For
details, refer to the component's operating instructions.
'*
Some models cannot be operated with this remote control unit.
To Next Page
Loading...
