Denon AVR-2309CI

ENGLISH
The auto setup measurement results are stored in the AVR-2309CI.
CD Press b.. to select" Store"''', then press <J .
• "Storing Please wait···" is displayed on the on-screen display
while the results
are being stored.
• When storing
is complete, "Storing complete. Auto Setup is now
finished." is displayed on the on-screen display.
(1) Select "Exit", then press <J.
CID Disconnect the setup microphone from the AVR-2309CI.
Error Messages
If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over
again.
I
Measures
accurate • Either turn off any device generating noise or move it
away.
•
Try again when the surroundings are quieter.
low for • Check the speaker installation and the direction
in
which the speakers are facing.
• Adjust the subwoofer's volume.
Cause
• Included setup microphone is not connected. • Connect the included setup microphone to the SETUP
MIC jack on the main unit.
• Not
all speakers could be detected. • Check the speaker connections.
• The front L speaker was not properly
detected.
• Too much noise
in the room for
measurements to be made.
• Speaker or subwoofer sound
is too
accurate measurements to be made.
Error messages (examples)
)
IJStore~
Cancel~
• Menu screen.
CD
(Step 5 : Store
OTo cancel storing
Press b.. \l to select" Cancel "''', then press <J.
• All the measured auto setup data will be erased.
-N·na
Do not turn the power off while the settings are being stored.
Ret r y ~
Cancel~
Auto Setup
=. Mu I tEQ
;::=~= ~_ •• ',U
~ § E7
IJ~Front
.;_~""'4
Ret r y ~
Cancel ~
• Displayed speaker could not be detected. • Check the connections of the displayed speaker.
· The front R speaker were not properly
detected.
· Only one channel of the surround speakers
was detected.
Sound was output from the R channel
when only one surround back speaker was
connected.
· The surround back, but the surround speaker
was not detected.
Auto Setup
=.Mul tEQ
r=~= G::_""U
\:l § E7
IJ~Front
• Displayed speaker connected with
polarities reversed.
the • Check the polarities of the displayed speaker.
•
For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you
are sure that the wiring is correct, select "Skip".
Ret r y ~
Cancel ~
Skip~
, Select "Retry" to measure again.
-n.na Be sure to turn the power off before checking the speaker connections.
28