ENGLISH
Default
Resets the settings to the default values.
1I0ispiay
Adjust display brightness of the receiver.
1m
Setup
Lock
Protect settings from inadvertent change.
II
232C Port
Set when external controller or 2-way remote control unit
is
connected.
_~[.ija
When using
the
AVR-2309CI
with
only
the
included remote
control unit (RC-1099), use Remote
10
"1" (default).
When using a separately sold remote control unit (RC-7000CI, etc.).
this function
can
be
used. Match the
ID
setting of the remote control
unit and the receiver.
I
Remote
10
Setup
ID.
[Selectable items]
IT]
2
3
4
[Selectable items]
I
Bright
I:
Normal display brightness.
Dim
Reduced display brightness.
Dark
. Very
low
display brightness.
OFF
Display
is
off
unless controls are operated.
~
Operating from the main unit
Press
<DIMMER>
~
Bright - Dim
---r
~
OFF
- Dark -----.J
When setting to "OFF", the display brightness of the menu setting
in
operation changes to "Dark".
[Selectable items]
ON
:Turn protection
on.
~
:Turn protection off.
#'
-When
"Setup Lock"
is
set to
"ON",
the settings listed below
can
no longer
be
changed. Also, "SETUP LOCKEDI"
is
displayed if you
attempt
to
operate related buttons.
RESTORER
Night Mode
Parameter
MultEO
Dynamic
EO
Dynamic Volume
Channel Level
. Audio Delay
-
To
cancel the setting, press
<MENU>
or
[A.MENU]
to re-display the
"Setup Lock" screen, then change the setting to "OFF".
[Selectable items]
I
Serial
Control
I:
Set when using
an
external controller.
2WayRemote
Set when using a 2-way remote control unit.
-N·ija
When using a 2-way remote control unit (RC-7000CI and
RC-7001
RCI,
sold separately). set this to "2Way Remote".
37 IFor details on
how
to
select. set and cancel settings for each menu, see
"Menu
Operations"
IGT'page
22),
To Next Page
Loading...
